10CompressorThreshold 0.0 to -60.0dB.Controls the level below which compressionstarts to take place.Ratio 1:1 to 20:1Ratio determines the amount of co
TOURBUSS operator’s manual11Using the SDX100Gain 0dB to +20.5dBDuring compression the signal is attenuated,gain may be required to produce the desire
12LimiterRelease50mS to 2.0 SecondsSets the length of time for the signal to return tonormal after the limiter has been active.Peak Threshold0.0dB to
TOURBUSS operator’s manual13Bracketing FilterL.F. 31.2Hz to 8kHzworks by severely attenuating frequencies belowthe cutoff frequency selected.H.F. 125
14Contact DetailsContact DetailsIf, for some reason, you have problems with the software try contacting Digidesign technical support at:Digidesign, a
2License AgreementCOPYRIGHTThis manual is copyrighted © 2005 by Drawmer Electronics, Ltd.With all rights reserved. Under copyright laws, this manual m
TOURBUSS operator’s manual3ContentsLicense agreementIntroductionAbout DRAWMERDRAWMERDRAWMERDRAWMERDRAWMERAbout the Drawmer TourBuss Plug-inPanel Over
4Panel OverviewThe Drawmer TourBuss suite consists of four effects - a Noise Gate, Expander, Compressor/Limiterand Bracketing Filter. Each accessible
TOURBUSS operator’s manual5Using the Drawmer TourBussKey Filters Control DescriptionUsing the Drawmer TourBussKey is the term used to denote a signal
6ExpanderKey Filters:As described in Key Filters section.Expander:Threshold 0.0 to -50.0 dBSets the level below which expansion starts totake place. F
TOURBUSS operator’s manual7be greater than the gaps in the musicprogramme. i.e. the Expander will never get tothe Range floor. It is very common to u
8Noise GateKey Filters:As described in Key Filters section.Noise Gate:Threshold 0.0 to -50.0dBSets the level below which gating starts to takeplace. F
TOURBUSS operator’s manual9Noise Gate OperationThere are circumstances when the programme material is corrupted such as, in a multi-miked drum kit se
Comments to this Manuals